![]()
In the 2008 ide you would direct see the assemblies that are part of the coverage gathering during the run. In this list you need to select the “Code Coverage” item and mark the enabled check box. Here you need to select the “Execution Criteria” in the left list and then you can see at the bottom of the page the set of collectors that are enabled for a test run. Open the Local.testsettings file and there you will see a set of items you can configure on the left hand of the dialog. In Visual Studio 2010 you need to take the following steps: #VISUAL STUDIO CODE COVERAGE DISABLED CODE#Choose lower tested code execution time overhead or lower overhead on ram memory.When you want to Enable code coverage in an Unit test run in Visual Studio 2010 you may find that the steps you need to take have changed.The "C/C++ Code Coverage advanced options" section enables you to: These settings are described in Execution Tab Settings - Defining How Tests are Executed. Use the "C/C++ Code Coverage advanced options" from the Test Configuration's Execution Tab "Instrumentation features" panel to enable optimized coverage mode. The special optimized coverage instrumentation mode is only designed for application level testing and is not available for unit testing. ![]() Optimized Coverage Metrics for Application Coverage Monitoring Therefore there is no requirement to assure a fast link between host and target to minimize overhead. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |